Qualcomm Atheros QCA9377 ath10kダイレクトファームウェアのロードに失敗しました

Qualcomm Atheros QCA9377 ath10kダイレクトファームウェアのロードに失敗しました

私はAcer Spin 5ノートブックでArch Linux(4.8.13-1)を使用しています。 WIFIは動作しますがdmesg | grep ath理解できないいくつかのエラーがあります。

[    2.269128] ath10k_pci 0000:01:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
[    2.546004] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/pre-cal-pci-0000:01:00.0.bin failed with error -2
[    2.546040] ath10k_pci 0000:01:00.0: Direct firmware load for ath10k/cal-pci-0000:01:00.0.bin failed with error -2
[    2.556185] ath10k_pci 0000:01:00.0: qca9377 hw1.1 target 0x05020001 chip_id 0x003821ff sub 105b:e0a1
[    2.556192] ath10k_pci 0000:01:00.0: kconfig debug 0 debugfs 1 tracing 0 dfs 0 testmode 0
[    2.557620] ath10k_pci 0000:01:00.0: firmware ver WLAN.TF.1.0-00267-1 api 5 features ignore-otp crc32 79cea2c7
[    2.625627] ath10k_pci 0000:01:00.0: board_file api 2 bmi_id N/A crc32 93da0176
[    4.406204] ath10k_pci 0000:01:00.0: htt-ver 3.1 wmi-op 4 htt-op 3 cal otp max-sta 32 raw 0 hwcrypto 1
[    4.412611] ath: EEPROM regdomain: 0x69
[    4.412613] ath: EEPROM indicates we should expect a direct regpair map
[    4.412614] ath: Country alpha2 being used: 00
[    4.412615] ath: Regpair used: 0x69

lspci -vネットワークコントローラに関する情報の表示

01:00.0 Network controller: Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 31)
    Subsystem: Foxconn International, Inc. Device e0a1
    Flags: bus master, fast devsel, latency 0, IRQ 280
    Memory at b1000000 (64-bit, non-prefetchable) [size=2M]
    Capabilities: <access denied>
    Kernel driver in use: ath10k_pci
    Kernel modules: ath10k_pci

この問題を解決する方法を知りたいです。私はこれがコントローラに関して経験している問題のいくつかを解決できると思いました。大学WIFIに正しく接続できません。私はこれがに現れるこれらのエラーに関連していると思いますdmesg。 NetworkManager、connman、wicd、netctlを試しましたが、これを使用するとネットワークからIPアドレスしか取得できませんが、インターネットに接続できません。大学のeduroamネットワークと同じです。さまざまな設定を試しましたが、そのうち何も機能しません。

これはの出力ですiwconfig

wlan0     IEEE 802.11  ESSID:"MY-WIFI"  
          Mode:Managed  Frequency:2.437 GHz  Access Point: 3C:7A:8A:F7:A2:C8   
          Bit Rate=1 Mb/s   Tx-Power=20 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:on
          Link Quality=50/70  Signal level=-60 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:16   Missed beacon:0

lo        no wireless extensions.

そしてiwlist scan | egrep -i 'ssid|cipher'私にこれを与えました。

lo        Interface doesn't support scanning.

                    ESSID:"MY-WIFI"
                        Group Cipher : CCMP
                        Pairwise Ciphers (1) : CCMP
                    ESSID:""
                        Group Cipher : CCMP
                        Pairwise Ciphers (1) : CCMP
                    ESSID:"20da86"
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP
                    ESSID:"0856e0"
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP
                    ESSID:""
                        Group Cipher : CCMP
                        Pairwise Ciphers (1) : CCMP
                    ESSID:"\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00\x00"
                        Group Cipher : CCMP
                        Pairwise Ciphers (1) : CCMP
                    ESSID:"20da86"
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP
                        Group Cipher : TKIP
                        Pairwise Ciphers (2) : CCMP TKIP

ベストアンサー1

パーティーに少し遅れましたが、eduroamある時点では接続する必要がありますが、これが私の構成です(少なくとも私にとっては)。

Description='Eduroam Tartu Student Village'
Interface=wlp8s0
Connection=wireless
Security=wpa-configsection
IP=dhcp
WPAConfigSection=(
        'ssid="eduroam"'
        'proto=RSN WPA'
        'key_mgmt=WPA-EAP'
        'eap=PEAP'
        'identity="<mylogin>"'
        'password="<mypass>"'
        'phase2="auth=MSCHAPV2 password=<mypassagain>"'
)

そして私もあなたと同じエラーを受けました。場合によっては、ワイヤレスカードが奇妙に動作することがあります。最近のアップデート以降、睡眠から目覚めても再接続されませんね。

おすすめ記事