私はHP nc4400ノートブックでDebian 7を実行しています。これはIntel Centrinoチップセットを搭載した古いノートパソコンです。ファンが10秒間点灯し、20秒間オフになってから10秒間点灯したことを除いて、正常に機能します。
BIOSにはACPIやAPMへの言及はありません。dmesg | grep -i "acpi"次を返します。
0317)
[ 0.229900] ACPI: Dynamic OEM Table Load:
[ 0.229904] ACPI: SSDT (null) 001FB (v01 HP Cpu0Ist 00003000 INTL 20060317)
[ 0.230045] ACPI: SSDT 7f7f629b 004CB (v01 HP Cpu0Cst 00003001 INTL 20060317)
[ 0.230435] ACPI: Dynamic OEM Table Load:
[ 0.230439] ACPI: SSDT (null) 004CB (v01 HP Cpu0Cst 00003001 INTL 20060317)
[ 0.230701] ACPI: SSDT 7f7f5f53 000C8 (v01 HP Cpu1Ist 00003000 INTL 20060317)
[ 0.231101] ACPI: Dynamic OEM Table Load:
[ 0.231105] ACPI: SSDT (null) 000C8 (v01 HP Cpu1Ist 00003000 INTL 20060317)
[ 0.231211] ACPI: SSDT 7f7f6216 00085 (v01 HP Cpu1Cst 00003000 INTL 20060317)
[ 0.231603] ACPI: Dynamic OEM Table Load:
[ 0.231606] ACPI: SSDT (null) 00085 (v01 HP Cpu1Cst 00003000 INTL 20060317)
[ 0.244084] ACPI: Interpreter enabled
[ 0.244100] ACPI: (supports S0 S3 S4 S5)
[ 0.244121] ACPI: Using IOAPIC for interrupt routing
[ 0.244789] PCI: MMCONFIG at [mem 0xf8000000-0xfbffffff] reserved in ACPI motherboard resources
[ 0.245206] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness
[ 0.260264] ACPI: Power Resource [C220] (on)
[ 0.262871] ACPI: Power Resource [C228] (on)
[ 0.269881] ACPI: Power Resource [C329] (off)
[ 0.269959] ACPI: Power Resource [C32A] (off)
[ 0.270035] ACPI: Power Resource [C32B] (off)
[ 0.270113] ACPI: Power Resource [C32C] (off)
[ 0.270888] ACPI: EC: GPE = 0x16, I/O: command/status = 0x66, data = 0x62
[ 0.271132] ACPI: No dock devices found.
[ 0.271142] PCI: Ignoring host bridge windows from ACPI; if necessary, use "pci=use_crs" and report a bug
[ 0.274594] ACPI: PCI Root Bridge [C002] (domain 0000 [bus 00-ff])
[ 0.283058] pci 0000:00:1f.0: quirk: [io 0x1000-0x107f] claimed by ICH6 ACPI/GPIO/TCO
[ 0.285079] ACPI: PCI Interrupt Routing Table [\_SB_.C002._PRT]
[ 0.285255] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C098._PRT]
[ 0.285357] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C101._PRT]
[ 0.285421] ACPI: PCI Interrupt Routing Table [\_SB_.C002.C111._PRT]
[ 0.285491] pci0000:00: Requesting ACPI _OSC control (0x1d)
[ 0.285495] pci0000:00: ACPI _OSC request failed (AE_NOT_FOUND), returned control mask: 0x1d
[ 0.285498] ACPI _OSC control for PCIe not granted, disabling ASPM
[ 0.298542] ACPI: PCI Interrupt Link [C10D] (IRQs *10 11)
[ 0.298640] ACPI: PCI Interrupt Link [C10E] (IRQs *10 11)
[ 0.298735] ACPI: PCI Interrupt Link [C10F] (IRQs 10 *11)
[ 0.298829] ACPI: PCI Interrupt Link [C110] (IRQs 10 11) *5
[ 0.298923] ACPI: PCI Interrupt Link [C123] (IRQs *10 11)
[ 0.299016] ACPI: PCI Interrupt Link [C124] (IRQs *10 11)
[ 0.299110] ACPI: PCI Interrupt Link [C125] (IRQs 10 *11)
[ 0.299152] ACPI Exception: AE_NOT_FOUND, Evaluating _PRS (20110623/pci_link-184)
[ 0.299282] PCI: Using ACPI for IRQ routing
[ 0.306278] pnp: PnP ACPI init
[ 0.306293] ACPI: bus type pnp registered
[ 0.306470] system 00:00: Plug and Play ACPI device, IDs PNP0c01 (active)
[ 0.310002] pnp 00:01: Plug and Play ACPI device, IDs PNP0a08 PNP0a03 (active)
[ 0.310352] pnp 00:02: Plug and Play ACPI device, IDs IFX0102 PNP0c31 (active)
[ 0.310415] pnp 00:03: Plug and Play ACPI device, IDs PNP0c04 (active)
[ 0.310472] pnp 00:04: Plug and Play ACPI device, IDs PNP0200 (active)
[ 0.310520] pnp 00:05: Plug and Play ACPI device, IDs PNP0800 (active)
[ 0.310576] pnp 00:06: Plug and Play ACPI device, IDs PNP0b00 (active)
[ 0.310690] pnp 00:07: Plug and Play ACPI device, IDs PNP0103 (active)
[ 0.310749] pnp 00:08: Plug and Play ACPI device, IDs PNP0303 (active)
[ 0.310804] pnp 00:09: Plug and Play ACPI device, IDs SYN010f SYN0100 SYN0002 PNP0f13 (active)
[ 0.311066] system 00:0a: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.311677] pnp 00:0b: Plug and Play ACPI device, IDs HPQ0004 (active)
[ 0.311845] system 00:0c: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.312175] system 00:0d: Plug and Play ACPI device, IDs PNP0c02 (active)
[ 0.312190] pnp: PnP ACPI: found 14 devices
[ 0.312192] ACPI: ACPI bus type pnp unregistered
[ 0.312197] PnPBIOS: Disabled by ACPI PNP
[ 0.694522] acpiphp: ACPI Hot Plug PCI Controller Driver version: 0.5
[ 0.694789] acpiphp: Slot [1] registered
[ 1.209623] ACPI: Thermal Zone [TZ0] (43 C)
[ 1.245239] ACPI: Thermal Zone [TZ1] (47 C)
[ 1.245347] ACPI: Fan [C32D] (off)
[ 1.245425] ACPI: Fan [C32E] (off)
[ 1.245503] ACPI: Fan [C32F] (off)
[ 1.245582] ACPI: Fan [C330] (off)
[ 1.264245] ACPI: Thermal Zone [TZ2] (38 C)
[ 1.274458] ACPI: Thermal Zone [TZ3] (27 C)
[ 1.278192] ACPI: Thermal Zone [TZ4] (72 C)
[ 1.770523] ata1.00: ACPI cmd f5/00:00:00:00:00:a0 (SECURITY FREEZE LOCK) filtered out
[ 1.782791] ata1.00: ACPI cmd c6/00:10:00:00:00:a0 (SET MULTIPLE MODE) succeeded
[ 1.782796] ata1.00: ACPI cmd ef/10:03:00:00:00:a0 (SET FEATURES) filtered out
[ 1.830495] ata1.00: ACPI cmd f5/00:00:00:00:00:a0 (SECURITY FREEZE LOCK) filtered out
[ 1.842790] ata1.00: ACPI cmd c6/00:10:00:00:00:a0 (SET MULTIPLE MODE) succeeded
[ 1.842794] ata1.00: ACPI cmd ef/10:03:00:00:00:a0 (SET FEATURES) filtered out
[ 2.559585] ACPI: Requesting acpi_cpufreq
[ 2.573303] ACPI: Sleep Button [C249]
[ 2.573433] ACPI: Lid Switch [C241]
[ 2.578133] ACPI: acpi_idle registered with cpuidle
[ 2.579241] ACPI: Power Button [PWRF]
[ 2.608481] ACPI: AC Adapter [C1B2] (on-line)
[ 2.619330] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness
[ 2.620666] acpi device:01: registered as cooling_device6
[ 2.620899] ACPI: Video Device [C085] (multi-head: yes rom: no post: no)
[ 2.669097] ACPI: Battery Slot [C1B4] (battery present)
[ 2.669211] ACPI: Battery Slot [C1B3] (battery absent)
[ 3.865996] snd_hda_intel 0000:00:1b.0: power state changed by ACPI to D0
[ 3.866008] snd_hda_intel 0000:00:1b.0: power state changed by ACPI to D0
[ 7.577461] input: ACPI Virtual Keyboard Device as /devices/virtual/input/input11
私は実行してlm_sensors設定ファイルに思い出せない行を追加するようにしましたが、役に立ちませんでした。
（編集：/ etc / modulesに「loop」と「coretemp」を追加してサービスを再起動させました。）
AC電源で実行するときは、BIOSでファンを恒久的にオンにすることができますが、10〜20秒ごとにオン/オフを切り替えるよりも、必要に応じてオンまたはオフにすることをお勧めします。